optical switch on the Anycubic MEGA system

(ENGLISH)
This is a mount and push pin for installing an optical switch on the Anycubic MEGA system.
The response position of the z-switch can be adjusted with the screw on the z-carriage just like the stock MEGA system.

The original model is here (https://www.thingiverse.com/thing:4660123).

In the original model, the y-axis adjustment range of the switch position is too small to make contact with the switch.
We have remixed the mount to allow the switch to be adjusted back and forth.
In addition, the push pin has been lengthened to increase the Z-axis adjustment range.

For mounting instructions, please refer to the instructions for the original model, but I made the following changes in my environment.


I made a cable that splits one pin into two in order to branch to the left and right optical switches.
Point the branch cable to the 5V pin of the D42 to supply 5V to the left and right optical switches.

Since the switches are wired differently from the original mi