optimized CR-10 E3D V6/Volcano hotend mount

This direct drive hotend mount perfectly fits the E3D V6 and Volcano hotends and can swap between them witth nothing but a single screw. The mounting solution allows the entire assembly to be removed with a single screw making it alot easier to work on or build your extrusion system. with mounting solutions for the V6 and Volcano, it makes it quick and simple to switch from one to the other with just a single clearly marked hole for proper alignment. It also mounts a single 5015 blower fan (E3D sells them) for part cooling, providing over 3 times the cooling power of the original part cooling fan. The fan shroud is the same used by the Prusa MK3 so you know it is a solid cooling solution.

The design is highly optimized so it requires no support material and if you use a 0.5mm line width then it does not use any infill either, it will be totally solid for the best strength and optimal toolpathing. Prints in only 90 minutes with a 0.3mm layer height!