Thingiverse
Optocoupler case auto-bedleveling sensor
von bluecake
12
Downloads
9
Likes
0
Makes
This is a little case for the optocoupler wich can be found on aliexpress to put between your sensor for auto-bedlevelling and your motherboard.
It's not a tight fit but you could always use the 2 holes in the pcb to secure the board to the bottom of the case.
It's not a tight fit but you could always use the 2 holes in the pcb to secure the board to the bottom of the case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
