Orange Peeler

I recently bought some oranges and was reminded of the orange peeler I used as a kid, which always made the orange-eating experience so much easier. No more digging into the thick peel with my nails or getting sore fingers from damaging my fingernails. To solve this, I modeled a peeler with a 6mm blade designed for that very purpose.Each peeler takes about 25 minutes to print, and if you duplicate the file and print 4 at once, it takes just over an hour. The model consists of three stacked parts, making it easy to print in 1, 2, or 3 colors, depending on your preference. Enjoy!, Disclaimer: While 3D-printed objects are generally not considered 'food safe,' this particular item is designed to only interact with the orange peel, not the actual fruit. Therefore, it should pose minimal risk. To maintain cleanliness, simply rinse it with water and soap after use. Over time, consider printing a replacement if wear occurs. However, please use this print with caution.Boost MeWant more