Thingiverse
Orange Pi Lite - Case with GPIO
von MazeMieter
48
Downloads
43
Likes
3
Makes
A case for Orange Pi Lite, with GPIO pins accessible.
It has a hole at the top that is tight enough to hold the antenna in place. It is a tight fit, no need for screws. And as you can see from the images the camera interface, IR receiver and reset button are not usable.
You might want to add four legs at the bottom to allow air to flow in, if you do a lot of RAM access.
It has a hole at the top that is tight enough to hold the antenna in place. It is a tight fit, no need for screws. And as you can see from the images the camera interface, IR receiver and reset button are not usable.
You might want to add four legs at the bottom to allow air to flow in, if you do a lot of RAM access.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
