Thingiverse
Orange Pi Zero 3 Case
por Po_temkin
3
Descargas
10
Likes
0
Makes
Hello to everyone!
This is a Orange Pi Zero 3 case in two design - with and without ventilation.
You can combine them because sizes of designs are similar.
In addition, you have a chance to mount your case using mount holes placed on the left side.
I also created the mount for V-slot profile.
But be careful with demensions, likely that you need to slightly adjust the part size for a couple of percents.
In my case, I printed mount with 1 perimert, 100 percent infill and maximum cooling - in this situation installation was very stiff.
This is a Orange Pi Zero 3 case in two design - with and without ventilation.
You can combine them because sizes of designs are similar.
In addition, you have a chance to mount your case using mount holes placed on the left side.
I also created the mount for V-slot profile.
But be careful with demensions, likely that you need to slightly adjust the part size for a couple of percents.
In my case, I printed mount with 1 perimert, 100 percent infill and maximum cooling - in this situation installation was very stiff.
Po_temkin también publica en
21 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
