Thingiverse
Orange Pi Zero Case (Extended)
por Sevary
10
Descargas
8
Likes
1
Makes
Case for the **Orange Pi Zero** with an **extension board** (Interface Board).
It has an opening for the *GPIO-Pins* and holes for better cooling.
Also there's an opening for the antenna, LEDs and the *IR-Receiver*.
You'll need at least four M3-screws.
My recommendation is to use *OPiZ-Bottom_2*, because it has openings for 4 screws, so you can use them as a stand. With this version, you'll need 6 M3-screws (2x inner, 4x outer).
There's no need for nuts.
It has an opening for the *GPIO-Pins* and holes for better cooling.
Also there's an opening for the antenna, LEDs and the *IR-Receiver*.
You'll need at least four M3-screws.
My recommendation is to use *OPiZ-Bottom_2*, because it has openings for 4 screws, so you can use them as a stand. With this version, you'll need 6 M3-screws (2x inner, 4x outer).
There's no need for nuts.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
