Thingiverse
Orange Pi Zero Re-Mix
von mhjorleifsson
4
Downloads
0
Likes
0
Makes
Changed the top vent and added a hole to run a ribbon cable to the GPIO ports.
Left the holes closed on the bottom to keep the bottom easy to print and just run a tap drill through it.
Also added mounting tabs to the sides for easy mounting to a case or wall etc.
Left the holes closed on the bottom to keep the bottom easy to print and just run a tap drill through it.
Also added mounting tabs to the sides for easy mounting to a case or wall etc.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
