Slicer Discord
OrangeRX JR Module antenna relocation – 3D printable model from Thingiverse Thingiverse

OrangeRX JR Module antenna relocation

by dmyers7
125 Downloads
73 Likes
9 Makes
Go to Model
2-17-2015 Quick update note: Per user Porksmash, it looks like HobbyKing has updated their orange Tx module to eliminate the micro coax as part of the internal design and thereby killing this hack. That said, you could buy a 70mm micro coax and matching 2.4Ghz Antenna from Aloft Hobbies .com and solder the micro coax directly to the board (signal and shield). You will have to remove the current connector to try and maintain proper signal characteristics. If you do this, !! make sure you range test !! Use hot glue to lock the coax in place once you have a working and range tested system. There is the possibility that if not done right the transmitter module can burnout mid flight and you will loose control of your aircraft. (i.e. you need to range check before and after the mod to insure the transmitted signal is as strong after the mod.) Personal at this point I would move onto the Spek Module hack and leave this one behind. Since I do not have possession of a new module I ca
Source
Thingiverse
What you need to print this: Intermediate Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Gluing
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection