Thingiverse

OrbiFan V1

by Orbitec3D

18 Downloads

10 Likes

0 Makes

~OrbitFan~
The Orbiter fan duct!

**12.Sept 2021: Full hotend assembly STEP file added.

Optmized for the Orbiter direct drive extruder.
(Here with the V1.5)

- Fully testes approx 24/7 for almost half a year. Runs good! High performence duct.
Prints smal details, and bigger models at over 300mm/s, (CR10s)

- Infill up to you. Minimum 30% i would recomend. 3-5 Perimeters.
Think i printed mine in 100%

- The design has been optimzed for minimal supports needed.
Se pictures where i add support blockers (!)

- Can be used without cabel chain, but designes for use with it.

- Bltouch mount is adjustable in the range recommended by the manufactor.

- Uses 5015 fans.

- Uses stock Creality hotend.

- Small printed spacer is just glued to the fan duct.

- The 4 holes in top side is for zip ties, regarding cable management.

- Fans are "Snap in place".

- 10 thread inserts are needed.

- PTFE Tube between Orbiter and nozzle should be around 79mm, but mak

5015 5015 blower 5015 fan duct 50mm blower air duckt blower fans mount cooling duct fan duct OrbiTEch3D Orbiter Orbiter extruder Orbiter V15 PLA Fanduct 5015 5015 blower 5015 fan duct 50mm blower air duckt blower fans mount cooling duct fan duct OrbiTEch3D Orbiter Orbiter extruder Orbiter V15 PLA Fanduct

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Why?

supports needed

Single piece Supports required

Supports 2/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer