Thingiverse
Orbital Sander - Paper aligner
por chrismolloy
94
Descargas
56
Likes
0
Makes
This is a remix of Sandpaper Helper for BOSCH Orbital Sander by Wherzog
I made the following changes
1) made it smaller to use less material
2) made it so it could be attached to the sander cord with zip ties so I could find it!
It uses the same pin spacing as the Sandpaper helper of 80mm. You can modify the Fusion 360 design file or the Step file to accommodate different spacings if required.
Here is a link to the Fusion 360 design file http://a360.co/2HaqklJ
I made the following changes
1) made it smaller to use less material
2) made it so it could be attached to the sander cord with zip ties so I could find it!
It uses the same pin spacing as the Sandpaper helper of 80mm. You can modify the Fusion 360 design file or the Step file to accommodate different spacings if required.
Here is a link to the Fusion 360 design file http://a360.co/2HaqklJ
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
