Slicer Discord
Orchid Wall Planter – 3D-Druckmodell von Thingiverse Thingiverse

Orchid Wall Planter

28 Downloads
39 Likes
0 Makes
Zum Modell
Grow and display Orchids on your wall with this combination planter and basket. The planter is designed for a standard tapered drywall screw, the head of which sits flush with the back of the planter once fastened. The planter has a dip in the front rim for easy grabbing and removal of the basket. The Basket has been designed with holes small enough to contain most moss/bark planting medium while still allowing for breathability and drainage. Living in an arid climate, I water my orchids once per week by submerging the baskets in water up to the rim for 5-10 minutes, then fully draining the basket before being placed back in the planter. The orchids shown are Keikis which were recently excised from a mother plant and are therefore still relatively small, but have plenty of room to grow.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen