Thingiverse
OrdBot Z Rod Stabiliser
par dbailey
54
Téléchargements
18
Likes
3
Makes
An arm which attatchs the the side of the Z Makerslides. Holds a standard ABEC bearing (Out of skateboard Etc) 22mm OD, 8mm ID, 7mm H.
Have to replace the 8mm threaded rod and increase the length to maintain 150mm Z travel. I cut the rods to match the height of the makerslides.
Used a thin layer of thin tape to ensure the rod sits snug within the bearing centre. Align the z motor once the bearings are installed.
*Not recommended unless you are using a floating z nut modification (Z Wobble Stabiliser)*
Have to replace the 8mm threaded rod and increase the length to maintain 150mm Z travel. I cut the rods to match the height of the makerslides.
Used a thin layer of thin tape to ensure the rod sits snug within the bearing centre. Align the z motor once the bearings are installed.
*Not recommended unless you are using a floating z nut modification (Z Wobble Stabiliser)*
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
