Origami Lid Box

I made a remodeling of Wim_V's Origami Lid Box.
I had a hard time assembling the lid hinge. They tended to break on me. Found it interesting enough to just make my own.

The main things I changed were
1) Lid hinges use a length of filament as a hinge pin.
2) Used M5x12 Butten Heads and nuts to attach the Lid to the Box and Knob.
I'm sure you can use socket head too. Just use a washer with them.
3) Pockets on the bottom for rubber feet.
Helps hold the box in place while operating the lid.
4) Removed the Latch.
Did not see the point. Though about a magnet but the M5 bolts I had were SS.
5) I guess I should add the gear teeth to this list.
This helped immensely in smoothness of the motion.
6) No L and R Lid parts
The small chamfers that Wim_V added were not needed. Could be because I did not have the lid nest into the box.

Lid
1 half of the lid is made from an Inside corner, Outside Corner and Center.
Connect them with ~11cm long length of fil