Original E3D Bowden Clip

The official original E3D v6 kit comes with a small bowden clip. I decided to recreate the same one so you can print replacements if needed. Additionally, you can print the larger one for use with the bowden pushfits also officially bought from the E3D's website.

* Small: Should be used on the original E3D v6 hot end.
* Large: Should be used on the original E3D pushfits.

I have also included the Blender files in case you want to edit it further.

**Change Log**
*2017-09-14* - Updated the Large clip to version 1.2 by increasing the amount that the clip encircles. I had issues where the previous version would fall off the pushfit after some time. The new one stays firm.
*2017-08-12* - Updated the Large clip to version 1.1 by increasing the thickness. The older clip appeared to be too thin to be used with the original E3D pushfits as there was still some free movement going on.