Thingiverse
Original Xbox Controller Stand/Cord Management
di astro_sam
16
Download
5
Likes
0
Makes
11/5/23 UPDATE: slight tweaks and added model for THE DUKE
Original Xbox parts are starting to get old (like all of us)! Controllers are starting to fail due to wear on the cable in certain spots that don't get a lot of strain relief, joysticks can chip, and buttons are starting to stick. It's hard to store them in a way that minimizes wear on all these parts. That's where this stand comes in! It plugs into the memory card slot and the cord is wound around it. It's a space efficient way to store the controller so that the buttons, sticks, and cord are (hopefully) safer than if you threw them into a drawer.
Printing:
* whatever infill
* PLA is fine
* recommend printing on its narrow edge w/ supports for speed and quality
* can get pretty tall with layer height
Looking for more Original Xbox stuff? Check out this: https://www.thingiverse.com/thing:5659797
Original Xbox parts are starting to get old (like all of us)! Controllers are starting to fail due to wear on the cable in certain spots that don't get a lot of strain relief, joysticks can chip, and buttons are starting to stick. It's hard to store them in a way that minimizes wear on all these parts. That's where this stand comes in! It plugs into the memory card slot and the cord is wound around it. It's a space efficient way to store the controller so that the buttons, sticks, and cord are (hopefully) safer than if you threw them into a drawer.
Printing:
* whatever infill
* PLA is fine
* recommend printing on its narrow edge w/ supports for speed and quality
* can get pretty tall with layer height
Looking for more Original Xbox stuff? Check out this: https://www.thingiverse.com/thing:5659797
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
