Ormerod 2 Power Switch + Cable Clip

A easy to use switch for the Omerod 2 printer. Easier than reaching around the back to use the existing switch. The switch bolts onto the side of the PSU plate with 4off M3 10mm Bolts.
The switch is wired to switch the mains input to the PSU and the LED is wired to the 12V output from the PSU. The cable clip is used to tidy up the wiring and stop it from rubbing against the Y axis end plate.

I found the switch on Ebay with this description "Mini Blue LED 19mm 12V Car Boat Angel Eye On/Off Latching Push Button Switch". The case was designed to take a switch requiring a 19mm hole.

Bolting the printer to an MDF board helps with general maintenance and 4 large rubber feet keeps it stable on the bench, it's also a bit quieter.