Ornamental Dish (Customizable)

This dish prints in two parts, the inner section prints the right way up, the outer section prints upside down. No supports required. There are 4 different shapes., A to D, and the Fusion 360 archive for customization.

These will print nicely from about 50% scale and upwards. The prints in the photos are at 50% and 70% scale.

After printing, the parts push together, I recomend using a few dabs of super glue to hold them in place.

Printing the inner section at 0.1mm layer height will give a nice smooth curve to the inner surface. The interface surface between the two parts uses 45 degree overhangs.

Please post your makes.