Oscilloscope Probe to Wire Adapter

SummarySometimes, when using an oscilloscope, it is desirable to be able to get the probe attached to the PCB. This may be to lower the loop inductance of the ground lead or just because the probe is difficult to hold in place.This adapter allows you to insert a probe and then use the wires to solder to the PCB. Micro-clips, alligator clips, connectors, etc. may be attached to the leads also.It was designed to fit a Siglent 200MHz PP215 probe, but I believe may fit many of the lower cost probes out there. I believe the PP215 is considered 4.5mm.If you discover other probes that fit, please leave a comment.The spring terminal are Molex 0008500113 These are available from Mouser and Digikey…probably other places. They come attached to each other with a carrier (material between spring terminals). Simply cut the carrier in between each spring terminal. The carrier material on each side of the spring terminal slides into a slot on each half of the adapter body.The wire I used was stranded