Thingiverse
OSSC holder
by kaputnik
14
Downloads
8
Likes
0
Makes
The Open Source Scan Converter is a wonderful piece of hardware, letting us use old consoles etc on modern TVs without analog video inputs.
It's not very heavy though. With a bunch of stiff cables connected, it's almost impossible to keep in place where you want it. Sometimes the cables even lift it off the ground.
Threw together this simple holder to remedy that. It can be attached to someting heavy, like a piece of thick sheet metal, etc, or directly to whatever furniture you keep the OSSC in.
I simply used double sided tape, but since the OSSC stands on rubber feet, there's enough room between the bottom and the holder for screws too.
Printed it with 100% infill to maximize strength, otherwise Prusaslicer PETG defaults.
It's not very heavy though. With a bunch of stiff cables connected, it's almost impossible to keep in place where you want it. Sometimes the cables even lift it off the ground.
Threw together this simple holder to remedy that. It can be attached to someting heavy, like a piece of thick sheet metal, etc, or directly to whatever furniture you keep the OSSC in.
I simply used double sided tape, but since the OSSC stands on rubber feet, there's enough room between the bottom and the holder for screws too.
Printed it with 100% infill to maximize strength, otherwise Prusaslicer PETG defaults.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
