Othello/Reversi Tray Cover

A tray cover for the Othello/Reversi board created by austinvojta. If you are like me and couldn't fit all 64 pieces in the trays, this cover holds the last 2 pieces (one in each cover). It also keeps the pieces from falling out when storing or transporting the game. This model prints just fine with no supports. I've found it easiest to remove the cover by pulling up in the middle of the cover where the game piece is stored. If you feel the cover is a little bit tight, try scaling the model up a couple of percentage points. For me, printed on the A1, it fit perfectly. The game board and pieces can be found here: https://makerworld.com/en/models/749919#profileId-683466