Otter Tent Pole Table Attachment

My take on a couple of variants of tables to be mounted on the Otter Flip Over sled tent poles as you can see in one of the pictures. To check compatibility, if you measure the pole, it should be about 20mm in diameter, if you get it working with other tents, please leave a comment about it, I would imagine it could work with round poles of similar size, should not matter to much. This is a lot of plastic to print, its around 300gr filament, I would highly suggest keeping an eye on the first layers, making sure the print gets a good start and good adhesion, once that is established, it should print no problem, its rather simple. I did not add Brim ears, but if you want a bit more security from lift up (depending on your setup) I suggest adding Brim ears. The modifiers adds some strenght to the parts that are supporting the “table”, where the poles go. The print is 4 wall, 8% infill, with 30% infill in the modifiers, 4 walls might be overkill, I think you could get away with 2-3 walls,