Oui Jar Lid

This was created because I wanted to re-use Oui Yogurt jars to store small parts. After looking all over the internet, I didnt find what I wanted so I made my own. This lid DOES seal VERY well and so far all the ones I have made are water tight, however I am not sure they are air tight. You can go out and buy lids from Yoplait at about $1.00 USD a piece, but I figured why not print my own at about $0.25 USD ea. This design has an internal ring that acts like a primary seal around the inside lip, and the outside lip snaps over the rim, securing the lid in place. Post process I do run a green Scotch Brite style pad around the inside lip to remove any stray pieces of filament after printing. I dont know if this improves the sealing capabilities, but I figured it couldn't hurt, and may not be necessary.

My print settings are SLOW for TPE - Flexible Filaments

Anet A8 Clone Printer and IdeaMaker Slicer pared with OctoPrint

0.15mm Layer Height
3 Perimeters - Outside Perimeter L