Outback BBQ Foot

After nearly two decades of less than acceptable maintenance of the BBQ's, I had neglected to adequately oil the end grain of the legs which just stand bare, sucking up moisture. A bit of rot had set in so I figured a couple of feet would be nice.

I printed these in bright yellow because being health and safety conscious, wanted to make sure that visitors would see the BIG BBQ in the say and not stumble over it. (Nah, just kidding, I just happened to have yellow ABS+ loaded which prints well and I couldn't be bothered to change it, plus my wife likes yellow.)

These are for the Outback Hunter and Trooper BBQ's which happen to have slightly different sized piece of wood because...well why wouldn't you? I mean, if you were creating a range of BBQ's, it makes sense to NOT have uniform sized bits of wood right?

Print at your own risk, no liability accepted if your BBQ goes up in flames, the food gets burnt or someone trips over your BBQ if you print in any other colour than yell