Thingiverse
Electronics
Model downloaden
Outdoor Sensor Enclosure
128
Downloads
75
Likes
0
Makes
This is a simple, 32mm pipe attachable, multi-sensor enclosure, for outside projects.
Remember, if you are printing with PLA, you MUST spray some paint, resin or something resistent to the environment. PLA it's not water proof, it tends to absorb water.
You have to print it with the fins pointing upwards.
UPDATE -- 12/06/2017
The sistem works perfect. the sensor I put inside are the MQ2 and the Shinyei PPD42. It resist below 0°C and heavy rain.
Remember, if you are printing with PLA, you MUST spray some paint, resin or something resistent to the environment. PLA it's not water proof, it tends to absorb water.
You have to print it with the fins pointing upwards.
UPDATE -- 12/06/2017
The sistem works perfect. the sensor I put inside are the MQ2 and the Shinyei PPD42. It resist below 0°C and heavy rain.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
