Thingiverse
Overcenter Broom Clamp
von Dezign-it
159
Downloads
391
Likes
3
Makes
Designed in onshape.
This item is to be printed in one piece laying on its side, once the print is complete gently crack the pivot points.
If this item is scaled the hinge clearances will be looser depending on the amount scaled.
This item is to be printed in one piece laying on its side, once the print is complete gently crack the pivot points.
If this item is scaled the hinge clearances will be looser depending on the amount scaled.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
