Thingiverse
Overhang angle test
by Techniktoni
4
Downloads
1
Likes
1
Makes
The test is a overhang test. I used PLA-tec from http://two-bears.eu/
I have made printed it without any Support material.
The test starts in a angle of 45° and goes up to 75° in 5° steps.
There is no must to do it with Pla.
Disscussion about it at :
https://www.facebook.com/photo.php?fbid=1352105028185749&set=pcb.1290047124415507&type=3&theater
I have made printed it without any Support material.
The test starts in a angle of 45° and goes up to 75° in 5° steps.
There is no must to do it with Pla.
Disscussion about it at :
https://www.facebook.com/photo.php?fbid=1352105028185749&set=pcb.1290047124415507&type=3&theater
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
