Thingiverse
Overhang Support Test
von irvshapiro
16
Downloads
23
Likes
0
Makes
This model is used to test your printers ability to print overhangs and to test a slicers ability to add supports.
It includes overhangs at 90 degrees, 75 degrees, 60 degrees, and 45 degrees. In addition, it includes a 20mm bridging test.
The sample was sliced with Cura 4.0, and printed in Hatchbox PLA at 206 degrees.
It includes overhangs at 90 degrees, 75 degrees, 60 degrees, and 45 degrees. In addition, it includes a 20mm bridging test.
The sample was sliced with Cura 4.0, and printed in Hatchbox PLA at 206 degrees.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
