Slicer Discord
Overhang Test – 3D-Druckmodell von MakerWorld MakerWorld
Test Models

Overhang Test

48 Downloads
3 Likes
17 Makes
Zum Modell
I designed this quick-print calibration model specifically for testing a new filament. This fast-print overhang test helps you quickly dial in nozzle temperature, fan speed, and ideal support angle before moving on to bigger projects. The model displays overhang angles from 0° to 90°, but instead of the usual 0–90 numbering, it’s labeled 90–0. This makes slicer calibration much easier: if the print begins drooping at, for example, “15,” you simply enter 15° into your slicer without needing to calculate anything yourself.When testing temperature, you’ll notice its effect almost immediately. If the nozzle is too hot, the overhangs begin to droop and surface details soften. If it’s too cold, layer adhesion becomes weak, edges may chip, and the print might feel brittle.-Adjusting the temperature in small increments around 5°C at a time usually helps you find the ideal balance where overhangs stay sharp while layers remain strong and well-bonded.Fan speed also plays a major role. Higher coo
Kategorie
Test Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen