Thingiverse
Overlord Pro - umbilical plug
por bummster
11
Descargas
9
Likes
0
Makes
Printed at .8 shell and hollow.
A plug for the hole that the umbilical passes through. You will need to remove the shiny black plastic cover that is held in place with two 3mm screws.
This also helps to keep the umbilical from getting caught in the limit switch area as it guides it down and somewhat away from there.
It's a very tight fit, and I had a heck of a time with the small overhangs, so please leave your feedback if it doesn't fit for you. Be careful of course. If you break something, not my fault. :)
v4 has 2mm wide tabs.
v5 has 1mm wide tabs around the top and 2mm wide tabs around the bottom.
A plug for the hole that the umbilical passes through. You will need to remove the shiny black plastic cover that is held in place with two 3mm screws.
This also helps to keep the umbilical from getting caught in the limit switch area as it guides it down and somewhat away from there.
It's a very tight fit, and I had a heck of a time with the small overhangs, so please leave your feedback if it doesn't fit for you. Be careful of course. If you break something, not my fault. :)
v4 has 2mm wide tabs.
v5 has 1mm wide tabs around the top and 2mm wide tabs around the bottom.
bummster también publica en
4 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
