MakerWorld
Sculptures
Go to Model
Overtaken
16.1k
Downloads
8.2k
Likes
8.7k
Makes
About the model: After my Transcend model was so well received, I decided to make a new design with a similar concept. If you like this, check out Unbound too. (preview below) Print guide: Not scalable. Must be printed with 0.2mm layer height. Please just use the provided print files without modifications. Getting it off the plate and removing support is actually not as dangerous as it seems. The strings have quite a lot of flexibility so they won't get damaged from a little bit of bending. Be careful tho. Commercial License: You can subscribe for a commercial license membership on my Patreon or here on Makerwolrd: Membership
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
