Overture Double Spool Holder

I wanted a filament holder for two Overture spools.

Add (8) 608-ZZ 8x22x7mm bearings link below from Amazon.
The pegs are a perfect fit for the bearings, but just in case, they are tapped at 1/4 x 20.

https://www.amazon.com/dp/B085XTK1SL/ref=cm_sw_r_oth_api_i_vF.IFbFPP8SQN

Overture spools are 67mm wide. Smaller spools will fail unless you double up on the bearings. (1/4 x 20 tap really comes in handy there!)

There are two versions available - one is blank, the other has some extrusions to save filament... Creality Logo. And mine.

There are also (2) 2mm holes up front to hold loose filament for single filament extruders - always nice to have the next spool ready for a filament swap.

If you feel the need to mount it, I put (4) 1/4 x 20 tapped holes on the bottom.