Overwatch display stand

This was designed to complement the soldier 76 helm that I printed for my display case.

The main base was printed in grey pla with the logo printed both in white with the top little bit spray painted orange. They were designed to slot into the main base with the orange part glued in place. The main part of the logo is a little bit difficult to put in with you having to bend the middle bit vertically to clamp over the main stem on the base and with the tight tolerance of the image I didn't have to glue it down.

Then glue a rare earth magnet to the stand and the helm (stack them up if its not keeping it in place properly). Or just glue the helm straight to the stand