Overwatch logo LED wall light

This is a remix from https://www.thingiverse.com/thing:542637
I was unable to link the two things, but that one was used for base.

Printed on Wanhao Duplicator 12 (D12/300)

I scaled the original model up to 50cm diameter and split it in to pieces to be printed on 300x300 build plate.

All six pieces sanded a bit and glued together using superglue. For the top part I recommend also adding some hot glue, as the joint between top and sides is a bit too small for only superglue.

When sanding the connection parts, periodically check if they fit together good. As you can see, I have some connection lines showing, but that could later also be sanded a bit and covered with some white paint or nail polish.

LED strip was also hot glued to the inner sides. If I had a longer strip, I would probably also extend it to the prongs, as they are not fully lit up currently.

PRINTING:
Sliced with CURA.
Pieces can be rotated to fit 300x300 build plate. I was also able to fit side1 and s