Thingiverse
Owl
von 1rUsK
0
Downloads
0
Likes
0
Makes
!!!Attention!!!
For a printer with 1 extruder, it is necessary to print with a 0.2 layer, otherwise you can get a not beautiful owl. Also, do not enlarge the model for a single extruder.
To print with 1 extruder, you need to program a stop in the slicer on the following layers : 0Blасk 7Yellow 12Whitе 16Blue 20Violet. You need to change the plastic at each stop.
There are also models called: For 5 extruder printer. Up to ..... optimized for printing on bambu lab with 5 extruders.
For a printer with 1 extruder, it is necessary to print with a 0.2 layer, otherwise you can get a not beautiful owl. Also, do not enlarge the model for a single extruder.
To print with 1 extruder, you need to program a stop in the slicer on the following layers : 0Blасk 7Yellow 12Whitе 16Blue 20Violet. You need to change the plastic at each stop.
There are also models called: For 5 extruder printer. Up to ..... optimized for printing on bambu lab with 5 extruders.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
