Thingiverse
Owlbear (Remix)
por Handi75
74
Descargas
33
Likes
0
Makes
I just remixed this.
Nothing Special, All I done was Added a 2" Base to it.
I printed this with .4mm Nozzle with .2mm layers but this mode would highly be recommended with it's detail to print with a .2mm Nozzle at .12mm Layers.
It does say, in Cura that it's NOT Watertight, so I'm not quite sure how to fix this.
Nothing Special, All I done was Added a 2" Base to it.
I printed this with .4mm Nozzle with .2mm layers but this mode would highly be recommended with it's detail to print with a .2mm Nozzle at .12mm Layers.
It does say, in Cura that it's NOT Watertight, so I'm not quite sure how to fix this.
Handi75 también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
