Thingiverse
OXO tong handle
by peter120
0
Downloads
0
Likes
0
Makes
The original OXO tong handle has a rubber surface coating that became a sticky mess.
This was printed in carbon fiber PC at 250C on a 150C bed with 0.1mm layer height. The original part used a stainless rivet that needs to be cut and is replaced by a 4-40 stainless bolt in the printed part.
Designed in Fusion 360
This was printed in carbon fiber PC at 250C on a 150C bed with 0.1mm layer height. The original part used a stainless rivet that needs to be cut and is replaced by a 4-40 stainless bolt in the printed part.
Designed in Fusion 360
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
