Thingiverse
P1P Spool Roller
di Orang_Lad
2
Download
1
Likes
0
Makes
NEEDED
- 2x 608zz bearings
- adhesive (optional)
- P1P Spool Holder
NOTE: Supports are somewhat difficult to remove.
The bearings should fit snug into the housings, but the ends of the roller rod will need to be glued into place (or not, it seems to work fine without glue too). The roller does have a bit of wiggle without glue, but with a small amount of pressure it seems to grip the bearing just fine. This is a simple roller I made for fun, it seems to work well.
- 2x 608zz bearings
- adhesive (optional)
- P1P Spool Holder
NOTE: Supports are somewhat difficult to remove.
The bearings should fit snug into the housings, but the ends of the roller rod will need to be glued into place (or not, it seems to work fine without glue too). The roller does have a bit of wiggle without glue, but with a small amount of pressure it seems to grip the bearing just fine. This is a simple roller I made for fun, it seems to work well.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
