P1S top spool mount

A simple top mounted spool holder for your P1S (or P1P). May fit X1C but I am not certain they have the same top ledge for this to fit. I made this to print specifically with TPU, as it lessens the friction going into the extruder. I suggest removing the PTFE from the extruder and substituting it with a short (~20-30mm) piece) which the filament can go directly into. After printing 2 of the bridge pieces and the reel, remove the top glass and install the bridge pieces on the edge of the top channel (as shown in the GIF). Line them up with each other in the middle and place the reel part between them, with the spool attached. Where you place the bridge pieces is up to you, however I suggest you position them more towards the rear of the printer. This will depend a lot on how much filament is left on your spool. I suggest printing the default profile, as it has painted on supports. I used PETG for mine but PLA will be fine. The structure is very sturdy when installed. I have added a 10mm