P2S Bidirectional Door Handles

This is a replacement for the door handle on the Bambulabs P2S, compatible with hardware used to install the original handle. No additional tools or parts necessary! I find the original handle to be a bit useless, so I created a slightly larger version with a more prominent handle that you can get your finger underneath to open the printer easier without obstructing too much of the viewport. I, personally, love the vertical handle because it's not in the way and allows ease of opening without getting fingerprints on the glass of the door. Simply take off the existing screws with the H2.0 hex key that came with your printer, remove the original handle and pry out the 8mmx5mmx3mm magnet from the inside (I used a retractable knife, but you can also use the hex key to get under the magnet and pry it out). Then, put that magnet into the desired handle (on the side that will be facing the right-most side of the door) and screw it onto the door using the existing screws and H2.0 hex key.