P2S Buffer Guide + Quick Release

Following my previous models Guide + Quick Release for AMS Buffer and AMS Hub Guide + Quick Release, I could not let my P2S without the same upgrade! 😁So here it is now, the P2S Buffer Guide + Quick Release! The goals are still the same :keep the perfect alignment of the PTFE tube at the exit, and keep this as close as possible of the internal sliding system, where other models are sometimes bolted far away from the Buffer, this one will guide the filament right at the exit of the system. This can remove issues with retractation error messages when the AMS failed to pull or push the filament, it also reduce the wear of the mechanism and the PTFE tube as the filament has less frictionadd a quick and tool-less release of the PTFE tube is an obvious advantage : with a small push on the buttons the PTFE tubes will be released, no need for a tool anymore, no need to fight with the tip of your fingers anymore. It is even better if like me the access to the back of your printer is not easy<i