P2S feed inlet bracket PTFE splitter

P2S的进料口太靠边，为TPU增加的任何三通都会严重下垂。这里给分线器设计的承托支架，以减轻PTFE料管弯曲压力，降低进料阻力，延长使用寿命。需拆下原来的一个螺丝，换成稍微长一点的，m3x5到m3x7应该都可以。图中三通Y分流器来自于https://makerworld.com.cn/zh/models/738336-ji-zhi-si-hua-de-yfen-xian-qi-er-jin-yi-chu-san-to The P2S’s feed inlet is too close to the edge; any Y-connector added for TPU sags badly.This support bracket is designed for the splitter to relieve bending stress on the PTFE tube, reduce feed resistance and prolong service life.Remove one of the original screws and replace it with a slightly longer one—anything from M3×5 to M3×7 should work.The Y-splitter shown in the image comes from:https://makerworld.com.cn/zh/models/738336-ji-zhi-si-hua-de-yfen-xian-qi-er-jin-yi-chu-san-to