P2S Screen Angle Mount – 45° Down Tilt

Default issue on the first model that could cause the screen to disconnect when being set up; this has been corrected. If your P2S printer is placed on a high shelf or rack, the screen becomes difficult to read because it only tilts upward. This P2S Screen Angle Mount solves the problem by tilting the screen 45° downward, making it much easier to see and use. The mount installs between the printer and the screen, allowing the ribbon cable to pass through a dedicated opening. The screen can then be reconnected and clipped back into place normally. This is a simple and clean mod that greatly improves usability when your printer is positioned above eye level. Designed by Hackman3D. 🔧 InstallationUnclip the screen from the printerDisconnect the ribbon cableInsert the Screen Angle Mount between the screen and the printerPass the ribbon cable through the holeReconnect the ribbon cableClip the screen back into place No modification of the printer is required. 🖨️ Print SettingsMaterial: PLAS