Thingiverse
P300 Panel Extender Gap Cover
von HappyAntics
0
Downloads
3
Likes
0
Makes
Gap filler for the p300 front panel extender by csmarzik.
This is my first print make, you may need to adjust the position of it in your slicer, face down no support is required. It was designed as 2 parts so it'll fit on a 225×225×265mm print bed.
Updated version has a slot and key for top and bottom pieces with a tolerance of 0.2mm
Use glue to attach to the panel extenders.
mirror two other ones if you want.
This is my first print make, you may need to adjust the position of it in your slicer, face down no support is required. It was designed as 2 parts so it'll fit on a 225×225×265mm print bed.
Updated version has a slot and key for top and bottom pieces with a tolerance of 0.2mm
Use glue to attach to the panel extenders.
mirror two other ones if you want.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
