Thingiverse
P90 Handguard
von Superpoo
50
Downloads
59
Likes
0
Makes
Bing Feng P90 Handguard
Only mods required are to drill out the lower mounting point, it's in the location of the receiver screw. I dremmeled out the inside so it was flush and epoxied the internal mount to one side of the receiver.
You will need some hardware:
2 x M4 standoffs, 20mm long
https://www.aliexpress.com/item/1005002913946631.html?spm=a2g0o.order_list.0.0.783f1802ISaihU
2 x M4 set screws 12mm long
4 x M5 Counter sunk set screws 12mm long
Only mods required are to drill out the lower mounting point, it's in the location of the receiver screw. I dremmeled out the inside so it was flush and epoxied the internal mount to one side of the receiver.
You will need some hardware:
2 x M4 standoffs, 20mm long
https://www.aliexpress.com/item/1005002913946631.html?spm=a2g0o.order_list.0.0.783f1802ISaihU
2 x M4 set screws 12mm long
4 x M5 Counter sunk set screws 12mm long
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
