Thingiverse
Pacing horse
von wasjans
6
Downloads
6
Likes
0
Makes
I found this horse on myminifactory and tried to print it.
Worked out pretty well.
I did not use infill so i had to fuse some parts afterwards. The top of the back seperated due to shrinking. I heated up the part and gently forced them together. Also the front leg which is of the ground broke from its supports. i had to use my hand 3D printerpen to fuse it.
I used custom supports in Cura an also minimal boomsupport.
https://www.myminifactory.com/object/3d-print-pacing-horse-103084
Worked out pretty well.
I did not use infill so i had to fuse some parts afterwards. The top of the back seperated due to shrinking. I heated up the part and gently forced them together. Also the front leg which is of the ground broke from its supports. i had to use my hand 3D printerpen to fuse it.
I used custom supports in Cura an also minimal boomsupport.
https://www.myminifactory.com/object/3d-print-pacing-horse-103084
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
