Thingiverse
PacMan Chaser Fruit
von RobbyPants
23
Downloads
15
Likes
0
Makes
Our theme for the food drive at work was Pac-Man. I found the files for Pacman and the Ghosts quite easily. However, since this was for a food drive, I wanted the food to be featured in the display. Didn't find any, so I created them. I scaled them as best I could based on AliG3D's design. For the food drive, I decreased the thickness of the original pacman/ghosts from 18mm to about 6.6, and the fruit is built to match. I've included a picture of the original Pacman thickness next to the fruit. I didn't put slots for magnets, but these did end up on the fridge, so maybe that's the next design step for these. I'm not very experienced in design, so you might have to scale down the seeds/whites or do some sanding to fit. I did my best and I hope they're ok.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
