Pacman Ghost Lamp Animated

I created this Lamp as a learning experience in Fusion 360. I used WLED running on a esp 8266 as a controller (any wled controller will work). Not sure if I have a photo showing it but I wrapped the back inner boarder with 2 strands of LEDs to give the sides color and then used the LED Platform to hold all the LEDs that light the face. There is not much room when you apply the LEDs to the LED platform for the LEDs to wrap around to the back of the plate to allow the LEDs to be solders together so it might be a little tricky for people that do not have experience with soldering led strips. I did not provide any documentation for how to wire and setup wled. That is a learning process by itself, but not extremely hard. It may take time and AI will help a lot to learn it. I basically just make segments for each line of the eyes and then a playlist that changes the preset every few seconds. For the LEDs I used WS2812B IC RGB 5050SMD ECO Individual Addressable LED Strip Light, 16.4FT 300LED.