Pad attachment buckle

I designed these buckles to keep your ultralight quilt attached to the sleeping pad. One of the lightest options to do so. You just need some 1.5mm elastic cord, make loops and put them around your sleeping pad.

They are attachable to 3 different webbings. The hole is slightly smaller than the corresponding webbing so it doesn't dangle around. Available in closed or open loop.

10mm (3/8")
12mm (1/2")
15mm (5/8")


Printing:
I suggest printing at slightly higher temps for better layer adhesion. Calibrate your bed well so the elephant foot is minimal or tinker with initial layer horizontal expansion for best results. Your usual 0.4mm nozzle and 0.2mm printing height will do. 30-50mm/s printing speed is ok. Wall line count should not be less than 3

If you like my work you can support me directly by buying something from my small (DIY/outdoor/sewing) store:
https://www.adventurexpert.com/