Thingiverse
Paint Holder and Tray
von birgirth
0
Downloads
0
Likes
0
Makes
Paint holder and tray that I made for my daughter. Outer circle is where you put your paint and you can keep few army painter colors in the middle. If you print the disk also you need 608 bearing to put in the hole under the tray and then disk should go into the middle of bearing and then you can spin the tray.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
